Originally Posted by tomhliles

i said sl 50, tp 50
like dude said, gbp jpy moves to much for just 25
im doing the exact same thing your doing, just a diferent pair, at a diferent time, for a diferent amount
i use the manage tp ea, sometimes price goes up to 20 30 pips n turns around
so i move stop to break even at about 22 pips, then at about 40 pips i move stop up 10-15 pips, plus close half the lots, final tp is 45-50
this dont work on gbp-usd
stick to 15 lots there
the ea manages the trades, yes i place trades at midnight

Originally Posted by tomhliles

those results were plain tp 50, sl 50, no interfearance, except the next night, close any open trades n start over

i was gonna post a chart, but i cant seem to, may be my browser?

Originally Posted by RJ1

Hi all,

This is my result of trading AHAL from 24th to 27th April on NF demo account. Please take note that 24, 25 and 26 April, I traded with TP 15 and SL 30. On the 27th, I changed my trading rules a little bit to maximize profit. I maintain SL 30, but TP 0, where I put Trailing Stop at 15. I am going to test this new setup again next week to see if it is more profitable. In case you want to know, I trade manually but looking forward for an EA of course

-RJ1-

Originally Posted by metastock

HI RJ1! Compliments for yours results!!!!
On usdjpy you trade with the same roles of gbp/usd? I trade only g/u but anothers users seem have good results on different pairs....

Originally Posted by Forigo

Hello friends, here is EA based on AHAL strategy. Play with it .
Settings:
Begin - time to begin pending orders;
Length - bars ago to calculate Hi Lo;
EOD - time to end trading and close pendings;
Pips - pips from Hi Lo to set pendings

Wish success to all of you.

Originally Posted by metastock

Thanks Forigo to share your EA!!!
I try it but I have a problem: Breakeven. I try to put it to 0 but it anyway modyfy SL to entry value so many trades are closed with 0 pips of gain also when TP should be reach...
It's possible to disable breakeven option?? I try with 0 value but doesn't work