Maybe you want to set the mladen's version of STC, it's based on the original code. Cycle indicators

__________________

just these 3 indicators are all i use

there are dicey times in the charts during consolidation

but I stick to the european open and us open times and wait for a signal

wow just had a looky

the cycle point indicator is alot more accurate and gives uerlier signals than macd-dot
thanks for bringing it to my attention

I shall test on market open
if the indictor is for real - fodoesnt repaint it looks like the holy thingamagig they all seek

Attached Files

Cycle_Point_KROUFR_version_MTF.mq4 (13.0 KB, 292 views)

Perky,

I can't open this Cycle Point Indicator on my chart yet for some reason I have still to figure out but, I see that it is MTF and that it uses also a 240 minutes cycle in its settings. So be careful because these time frames longer than the current time frame may make it look a bit in the future.

thanks for the heads up - I saw that thats why i wanted to test it in live market
oh youll need this indicatro also

ummmmmmm here
the pointer feeds off this
thats why you aint gettin nothing
srry

Attached Files

Cycle_KROUFR_version_.mq4 (6.8 KB, 273 views)

but you will notice that the EMPTY squares are from the 240 timeframe
the filled in squares are from the live 1 hour chart

I'm 100 % sure that what you are seeing is repainting. Just place the cycle pointer indicator on a 4h chart...it's so accurate that it's actually absurd.

Should I be wrong through, I'll gladly wire you 100 bucks for pointing this indicator out to us...or actually even more, once I've made my first 1k ! All my financial worries would be gone then...sadly, though, this is very unlikely.

Sorry to spoil the weekend.

KROUFR was just made to see historical high and low.

For live trading, you can forget it.

The squares appears after a LOT of bars.

Sorry.

__________________
Picasso is the best !

This is what I have read, too. Even the MACD-dot will get you grilled in the long run.