Welcome to Forex-TSD!, one of the largest Forex forums worldwide, where you will be able to find the most complete and reliable Forex information imaginable.
From the list below, select the forum that you want to visit and register to post, as many times you want. It’s absolutely free. Click here for registering on Forex-TSD.
Exclusive Forum
The Exclusive Forum is the only paid section. Once you subscribe, you will get free access to real cutting-edge Trading Systems (automated and not), Indicators, Signals, Articles, etc., that will help and guide you, in ways that you could only imagine, with your Forex trading.
Elite Section
Get access to private discussions, specialized support, indicators and trading systems reported every week.
Advanced Elite Section
For professional traders, trading system developers and any other member who may need to use and/or convert, the most cutting-edge exclusive indicators and trading systems for MT4 and MT5.
Hi Trading MM
Sorry about the delay - did not check if I had any messages - these are the two indicators I use with MM to help determin the strength of the MM Level as to whether the Level will Hold or Breach.
can you make the histo in the guppy indicator similar to the one in macd 2 (where it changes color below the zero line - I think you add a buffer as in 3a & 3b in the macd 2 indicator) also can you make the histo in guppy with a width of 3 as it keeps reseting back to 1 or 0
As I said earlier that I have added the float2 indicator to work along side your guppy macd indicator to confirm with mm entry/exit.
enc float 2 indicator and piccy
ps the reason I rename indicators with a #00 prefix is so they will show up first in MT4 as the other indicators will grey out on selection if too many in folder
As I said earlier that I have added the float2 indicator to work along side your guppy macd indicator to confirm with mm entry/exit.
enc float 2 indicator and piccy
ps the reason I rename indicators with a #00 prefix is so they will show up first in MT4 as the other indicators will grey out on selection if too many in folder
xard777
Where can I find a description of the float indicator?
BTW, I will answer your (email)questions later today or tomorrow
I use the Float indicator to confirm the MM low & Highs - I tend to find that if the Float confirms 3 time frames with the same HIGHS or LOWS as the MM levels HIGHS or LOWS then that has the potential to be a strong reversal point, I find this works best using the 5 min, 15 min, 30 min & 60 min. I have taken the Data off the chart and placed it into the indicator window to make it easier to see, plus it leaves the chart comments area free to show the MM levels. I have included the Float Volume levels but as yet have not studied the significance of them although I understand the Volume has good trading value.
There is a slight glitch in the "Float Vol left" reading as it keeps changing to give the Float volume level but I am trying to fix that at the moment, I have also adjusted the CVEND & CVSTART lines to run right thru the chart & indicators. If you want the indicator I will post it when I have fixed it.
Thanks for the indicator(#00float2). When I applied to chart, I am not getting any data as shown in your post#131. There are no values except a sawtooth diagram. Kindly request help
Ops... I saw the data. It was buried on the main chart window by the MM Lines and label. How did you move data to the indicator window for better reading . Once again thank you
Linear Mode
