Quote:
|
Originally Posted by cre666
On that mater, could I open (drag&drop) phoenix on only one pair, some of them or should I use it on all of the pairs for it to be successfull? (the booster version had a very complicated set of instructions...).
|
You can put it on these pairs: GBPUSD, EURUSD, EURJPY, GBPJPY, USDJPY and USDCHF - these are supported, these have already seting hard coded if you use Prefsettings=true. You can use Phoenix in any combination (on one pair, two or three or all of them)
Which one would be the best. Hard to say. Because there were several changes while trimming out bugs, some if not all settings will probably need to be rewised and pairs optimized again. So expect in next week or two or so some changes. Now we are comming close to temp final version, and now will become right time to start with optimization. In the meantime, look at posted statements to see, which pair does the best.
I don't understand, what you mean with boster version. Phoenix boster didn't perform well and it was abandoned waaay back. Don't waste time with it. Rather focus on the later version.
Quote:
|
Originally Posted by cre666
BTW: I've read it earlier today, but I cant find it again. What is the main difference between mode 1, 2 & 3?
|
Mode1 - one trade
Mode2 - added second trade to first trade
Mode3 - three trades. main idea was, that (comparing with first mode) if first mode would sell at say 100 pips profit, then in mode three sells would be at say 80 pips (first trade), 100 pips (second trade) and 120 pips third trade. Depense of your settings of course.
Btw, check 4th msg of this thread. There is answer, where to look regarding differences betwen modes.
About MM - lower number (0.05) lower risk, higher number (you shoud not go over 0.3) higher risk. Don't know in % terms.
Mario